Some time ago I missed a deadline for a competition because I could not get my synopsis finished in time. The reason I didn’t have one prepared in advance was simple: I don’t like writing them. I don’t like how the synopsis reduces the story from a big house, rich in detail, to scaffolding. In truth, my synopses always run the risk of descending into the ‘and then this happened’ story telling of my 7-year old self. It was charming then, but not so inspiring now. So I put it off, as one does. My mistake.
However, whilst I fail at writing synopses, I am reasonably experienced at writing abstracts. In science, the abstract of a paper has much the same purpose as the synopsis, and it is often what determines whether a paper proceeds from the editor’s desk to the review stage. Get it right or get rejected. Sounds familiar? Unlike synopses, I actually like writing abstracts. Like how it is more precise than the meandering manuscript. Years of training have made a good abstract a thing to be achieved rather than avoided.
So, naturally I wondered if I could translate my appreciation for science abstracts to creative writing.
When I write abstracts, I go through the manuscript looking for key points from each section. These are the points needed for the experiment to make sense. Everything that is covered in the conclusions must be introduced in the results. Everything that is in the results, must arise from the methods. Everything that is in the methods must be supported by the introduction. I gather these points that I want to say, whittle them down and distill them into what I need to say in a few sentences. The trick is to determine what goes in and what gets cut. That means that anything that is, for example, in the methods but not needed for the results, gets scrapped, no matter how interesting.
Then I adjust the balance: no more than two sentences for introduction, two to three for methods, three to four for results, and one for discussion. I tighten the language as much as I can. Word limits tend to be strict (250 words is typical for my branch of science), so brevity is crucial.
Images from arguably prettier sciences than mine: Messier 101 (NASA/JPL-Caltech/STScI), Arches National Park, MSRA (NIAID, flickr.com/photos/niaid)
How does this translate to a synopsis?
I suppose it would look something like the following. First, read the story and take the plot points, chapter by chapter, to create a longish summary. From this, extract the major points needed for the story to make sense at every step and remove the points that are not necessary for the plot to work. This would be what is needed for the synopsis. Then, there is the balance to consider. If it follows the breakdown of scientific abstracts, we are looking at:
Introduction: A short background to set up the conflict (~20%)
Methods: How the characters try to fix or escape the conflict (~30%)
Results: The outcome of the attempted fixing/escaping, including escalation and further endeavours towards resolving the issue (~40%)
Discussion: The resolution with final point of character arch (~10%)
Of course, there is some flexibility in this division. It is not one size fits all. But for someone like me, having approximate targets is helpful. So 20-30-40-10 it is.
Then there’s the tightening of the prose, making sure to get the verbs strong, descriptions powerful and short, and the character(s) motivation clear. Cause and consequence, keep it simple but engaging, less ‘buts’ and ‘ifs’ and more ‘therefores’. Word choice needs to be good, to ensure both brevity and impact. Include (some) emotions and reactions, and exclude themes and analysis. There is a place for these latter aspects, but a short synopsis is not that. The last discussion point should indicate that there is a character arch, but detail is not needed.
This is followed by revising the living daylights out of the thing. I typically revise an abstract three or four times, then give it a few rounds of polish before sending it to collaborators. After feedback, there is another round of revisions, more feedback, then final polish. Last spell check. Done.
Following this strategy works for me in my day job, and I have started using it for synopses. It is not the only way to write a synopsis by any stretch of the imagination, and probably not the best approach either, but it slots in nicely with my training and helps me put in the work needed. If anyone has a better suggestion how to tackle this beast, I’d be keen to hear it.
How do you approach writing a synopsis?